The Cause And Repair Method Of Needle Skipping/broken in Computer Embroidery Machine

skipping stitch

1. embroidery stretched surface is too loose. Tighten the embroidered fabric;

2. The gap between the needle and the tip of the spinning shuttle is too large, and the relative position of the spinning shuttle is adjusted again;

3. The tip of the spinning shuttle becomes dull or slightly defective. Sharpen and polish the point of the shuttle;

4. The thickness of the embroidery thread is not matched with the machine needle, and the thickness model of the machine needle is selected according to the thickness of the embroidery thread;

5. embroidery press foot spring pressure is not enough or damaged, replace the embroidery press foot spring;

6.the needle tip is not sharp, bending hair. Changing needle;

break stitch

1.the fabric is too hard, you can try to spray water on the fabric or use a hot press to heat to soften the fabric;

2.use the wrong needle, some fabrics require a specific type of needle;

3. the spinning shuttle and the machine needle is not synchronized, when the spinning shuttle and the machine needle too tight, easy to break the needle, adjust the gap;

4.clamp pressure is too tight, surface tension is too large, adjust the tension;

5. the press foot hole, needle plate hole and the machine needle are not aligned;

6,.the frame Angle is wrong, adjust the frame Angle;