Daily Use/maintenance Of Embroidery Machine, Life Doubled

care and maintenance
 

1. spinning shuttle: should be every shift (8 hours) with a brush (or compressed air blowing) to remove non-woven dust and threads, every two weeks should be opened the needle board, a thorough removal, each time after cleaning up by the way to add a small drop of sewing machine oil, in order not to pollute the embroidery oil.

2. frame, drive guide rail: Mainly the cleaning of debris in the guide rail, because here is often the embroidery cut thread, non-woven fabric fragments into the place, so affect the movement of the frame, must always pay attention to check, usually try to avoid debris into, and according to the lubrication of the guide surface in time to add lubricating oil, should be 2 times a week (such as the loss of oil machine will appear pattern location, broken line, noise increase, Seriously affect the normal work of the machine).

3. the head clamp: Pick wire spring, alarm sheet, should always be kept clean, once dust and other pollution, will make the broken wire alarm failure, to the normal work of inconvenience, while paying attention to the rotation of the wire wheel, such as uneven rotation, not flexible, it may be the hole in the felt mud stuck and other effects, should be removed to ensure that the surface line smoothly over the line, and pay attention to the part does not need to add lubricating oil.

4. Needle rod frame roller slide guide rail: Because it is exposed, it must be checked and cleaned frequently to ensure that the color changing mechanism works normally, and lubricating oil is added once a week.

5. computer, electrical control and motor: Usually keep the environment dry, avoid the intrusion of dust and moisture into the computer box and electrical parts, should be kept well ventilated, timely remove the surface and interior of the computer box and the dust on the tail of the motor, once damp, must be taken to dehumidize treatment, the simple method can be used to use the hot air of the hair dryer to damp treatment, Before powering on the device, ensure that components such as connectors and circuit boards are absolutely free of moisture. At the same time, the connector of the electrical part should make it firm and reliable. Most electrical faults are caused by loose connectors or poor contact caused by dust attached to connectors.

6. Each rotating part: Usually should pay attention to cleaning, the remaining thread can not be placed arbitrarily, to prevent the rotating shaft or wheel entanglement, causing unnecessary failures, especially on the table can not pay off the ball and other debris, million line ball is wrapped by the lower axis or Y axis of the synchronization belt under the table, it will cause deformation of the synchronization belt, damage, frame can not move or not in place, so that the embroidery pieces scrapped. The machine stopped working because it could no longer work. ,

7. there is a red spot on the head (except for the wire wheel and the electromagnet clutch pinch) generally 4 to 5 days to add 7< oil (or 1:1 sewing machine oil and motorcycle oil), so that the oil does not leak from the bottom.

8. The refueling of the needle rod drive, add a drop of 7< oil a week (or use 1:1 sewing machine oil to add motorcycle oil), the multi-needle machine is added to the oil groove from the sink hole of the line picking guide rail, and the single needle machine is added to the oil spout from the active shaft hole above, that is, the needle rod frame is added to the bottom of the line picking gear.