What Should You Pay Attention To When Operating Various Accessories Of A Computer Embroidery Machine?

What should you pay attention to when operating various accessories of a computer embroidery machine?

  Nowadays, computer embroidery machines have replaced traditional manual embroidery. This not only makes embroidery simpler and more efficient, but also can achieve a lot of uniformity and multiple times that cannot be achieved by manual embroidery. However, computer embroidery machines have many accessories, and workers What should you pay attention to when operating?

1. When the pin position is at a high position, you cannot use your hands to move the dial, and you cannot move it to avoid getting stuck.

2. Before driving, you should make comprehensive preparations, such as embroidery patterns, pattern matching working modes, and embroidery parameters.

3. In order to prevent the equipment from leaking flowers, you need to check whether the handle has been put down before pulling the rod to start the machine. If you need to use zigzag embroidery, you also need to check whether the manipulator is installed in place before pulling the rod to start the machine.

4. When embroidering sequins, you must turn the switch of the sequin device to the upper position, otherwise it will not automatically rise and fall. The air pressure of the sequin restraining device also needs to meet the working requirements, and cannot be too large or too small.

5. If you need to process a three-in-one pattern, in order to avoid damaging the sequin frame, keep a certain distance between the sequin device and the embroidery frame. If you need to replace a new three-in-one combination pattern, you need to check the distance between the borders after the starting embroidery point is decided. .

6. If you need to carry out repair embroidery, you cannot move the embroidery frame at high speed. When you need to change the frame, it is recommended to fix the needle on the special head.

7. After each embroidery is completed, all the cloth clips need to be placed in front of the table when removing the cloth clips, but they cannot be placed behind the Thai plate or on the thread frame to prevent the cloth clips from being moved into the gaps of the connecting plates. affect the next assignment.